Magna / Verada owners from TR 1991 - TS 1995 Discussion here.
Hi all, I'm experiencing a problem that I hope someone can shed some light on. The car is a V6 TS Auto that runs very well except for the past week it cranks a couple of times longer when I try to start it cold and seems like it's not going to fire when it gets hot. It cranks for 4-5 seconds...
Could anyone help me please? i am trying to get the timing gear off the crank shaft of my motor, none of the pullers i have can get in behind the gear to gain a hold. Is there a specific tool (Mitsubishi) for this job? or a neat trick that i just don't know about? Cheers
I have a TS wagon Executive...2.6ltr EFI Auto Just lately, the car seems to go out of drive and rev if I put the foot down a little. It seems to now change gears at a much higher RPM unless I baby the throttle. Its as if there's not enough vacuum available to effect a gear change (old school...
please refer https://mmcdlogger.sourceforge.net/ I have made one( the first circuit, not the second ) and test on my magna tr 2.6, intending to get the some parameter. but something confusing me. when i send through rs232 data to aldl interface, whatever number i sent, whatever number i get....
is there any easy way to remove the fan pulley from a 94 magna 2.6 ? without dropping the motor
Hi all, Seems like I got some TCU ( Transmission Control Unit) related problem myself (91 TR 6 cyl 3 plug TCU) For the last couple of months, the car would intermittently clunk in reverse when I first started off from home and then be stuck in 3rd (I think) gear.. I would drive to the shop,...
Genuine Mitsubishi Workshop Manuals for TR/TS Magna- KR/KS Verada available for download in PDF here. No zip or rar file problems (yay!) but PDF will require Adobe reader to view. Be patient as this is a huge download but well worth it (1312 pages). When download completes save to your hard drive...
I've owned my Second Gen for about a year next Friday, and other than having what sounds like a tractor engine in it (Yep, It's an Astron), it's been fine. Over the last couple of weeks it's been having difficulty starting. Normally, it would crank but wouldn't fire when the key was turned to...
Hi everyone. 92 efi stopped while driving it the other day. After some searching on here i found the way to bypass the relay for the pump and was able to drive it home. Interestingly when i got home and pulled the wire i had running from the battery the car still kept running (i expected it to...
So as the title states, after finally getting the heads back on and ready to go for my victory drive....the bloody thing won't start. And of course it's not just ur average 'simple fix' it has to be difficult thankyou magna once again :/ So what its doing: Turns over and tries to fire...
Verada is missing badly -intermittently when under load (up hills). Runs fine when free revved or driven on the flat. If you put it in Drive and rev it with brakes on -i.e loaded - it misses and makes a loud metallic noise on the front bank as it misses, a bit bit like pinging from over-advance....
in order to replace the crankshaft oil seal, when loose the belt for alt and air conditioner, loose the bolt, but found the pulley is stuck to the crankshaft, making it hard to remove. Any idea? thanks
So following some issues with the idle of my car, I decided that I will order a new ISC (idle speed controller) and TPS (throttle position sensor with built-in idle position switch) Rang Mitsu and the prices were unbelievable so I got to looking around on evilbay. I have also discovered that...
I have tj magna 3.0L auto, when I started the car this morning, it start with a strange ticking sound, now while drive while it changes gears I'm getting this strange humming sound. Do I need to get specific magna ATF or can I get aftermarket stuff. Any suggestions
Hi All, My mum has a KR Verada Ei, with sagged suspension. She wants me to arrange it's replacement, which I'm happy to do, but she is adament that I must replace it with softer than factory spec springs. (She has a bad back, and does not want anything stiffer than factory). In order to get...
Hi, i have a TS i'm getting roadworthy for my son, it has slop on one end of the steering rack, i'm guessing it's the bush inside, is it available as a seperate part? Only seem to find the rack mounting bushes listed. PeterN
Hi there, I bought a great 1993 V6 TR Sedan for $1000. All in superb condition with only a small dent at the back. Interior all original and in immaculate condition. Great buy and love the car which has replaced my 1994 which came to the end of the road. Anyhow, my only concern is after...
Hey guys I currently have a 1993 TR Elite at 327,000kms and have the dreaded timing chain rattle, on and off ticking of the lash adjusters and blue smoke from the valve stem seals. I found a reconditioned head on ebay for $350 and a timing chain kit for around $110 and was wondering if it was...
I need some small work on my TR Magna, parking dents, I live in Campbell Town Tasmania. Can any club member recommend a good panel beater that will not charge like 'Ned Kelly?' also can any member recommend a good company to replace my headlining? I have had this car from new and am doing it up ....
If there is a thread for this please let me know. 94 ts auto mpi For some reason my car (when in overdrive) changes down one gear and back up constantly. With o/d off the car runs fine. I've tried a reset ( bat terminals off) still no difference. Replaced the overdrive clutch about 3 months ago....
There are currently 34 users browsing this forum. (0 members & 34 guests)
Use this control to limit the display of threads to those newer than the specified time frame.
Allows you to choose the data by which the thread list will be sorted.
Order threads in...
Note: when sorting by date, 'descending order' will show the newest results first.
Forum Rules